Russia, Chelyabinsk Region, Kusa, st. 3rd International, 1, housing 20

TOL-1 belt conveyor was modernized

We would like to inform you about the modernization of the TOL-1 belt conveyor to TOL-2. In the TOL-2 design, the belt tension units were improved, additional adjustments were added to change the belt offset, a cleaning scraper for the lower branch was added, and the general assembly concept was changed (modularity of the design). Now, thanks to the modular design of the conveyor, frame design (conveyor with its own bed) and built-in (the conveyor is built into the lathe bed) are possible. This solution allows installing TOL-2 directly into the bed of lathes (including those previously purchased) and solving non-standard tasks of aspiration of shavings and sawdust in any woodworking workshop.

Frame Built-in
TOL-1 belt conveyor was modernized TOL-1 belt conveyor was modernized

 

Also, the modularity of the design allows the manufacture of several options for assemblies, thus it becomes possible to choose any configuration depending on the wishes of the customer, then several options are presented:

Straight.
It is used for the removal of chips into a hopper in the form of a sawdust accumulator located below the floor level.
TOL-1 belt conveyor was modernized TOL-1 belt conveyor was modernized
Straight uphill.
It is used for the removal of chips into a hopper or cart in the form of a storage device for sawdust located above the floor level.
TOL-1 belt conveyor was modernized TOL-1 belt conveyor was modernized TOL-1 belt conveyor was modernized
Combined.
It is used to remove chips perpendicular to the machine bed, structurally consists of two conveyors.

TOL-1 belt conveyor was modernized